CAP100 Model
The CAP100 inline filtration system provides homeowners
with a significantly higher level of particulate filtration than
standard furnace filters or electrostatic filters, at an economical
cost. These high-performance, two-stage filtration systems feature
excellent dirt-holding capacity for long filter life, and low static
resistance (0.12" @ 1,200 cfm) to minimize the load on the HVAC blower.
With a rated efficiency of up to 97% at 6 microns, the CAP100 is
designed to capture fine particles as small as one micron in size that
pass right through furnace filters, such as fine dirt and dust, animal
hair and dander, soot, and pollens.
|
|
 |
CAP100-UVP Model
The CAP100-UVP model combines all of the particulate filtration and design
features of the CAP100 model with our UV Plus (UV and photolysis)
technologies for controlling bacteria, viruses, and other microbes, as well
as odors. The extra-long UV Plus lamp is located in a compartment between
the two filters. Numerous built-in safety features ensure that installers or
homeowners can not be directly exposed to the lamps. |
 |
|
SG100-UVP Model
If you have previously installed Space-Gard® 2200 air
purifiers, why just change filters during your next service? In about
the same amount of time you can upgrade to a product that
provides all the same particulate filtration and UV Plus technology
as the CAP100-UVP. The SG100-UVP model is specially designed for fast and
easy retrofit installation. Simply discard the used filter and plastic
filter compartment, and slide the SG100-UVP module into this place. The
filters and lamp are pre-installed, so no other parts or assembly is
required. Secure the SG100 unit to the Space-Gard® outer frame with zip
screws (included) using the pre-punched holes in the SG frame, and plug it
into a 115-volt outlet.
®Space-Gard
is a registered trademark of Research Products Corporation
|
 |
| Back to the
top |
|
